Scratch build : #905 Mustang

Ask other modelers for a little help / knowledge ?

Re: Scratch build : #905 Mustang

Postby Sai1704 » Fri Oct 04, 2013 8:38 am

Covered stab and rudder.
Image

I have changed the method I cover with. Here's how I go about it.

1. Glue stick is run over ONLY the edges that adhere to the tissue.
2. The tissue is laid over the frame and firmly pushed onto the edges. (covered dry)
3. Most of the wrinkles are removed and tissue is pulled as taut as possible by hand.
4. After the glue dries, a coat of Hand sanitizer ( :D , ethyl alcohol) is given to shrink the tissue.
5. The tissue is finally sealed of with Krylon Crystal clear spray.
Anirudh
Sai1704
 
Posts: 77
Joined: Mon Aug 19, 2013 7:14 am
Location: Bangalore, India

Re: Scratch build : #905 Mustang

Postby Sai1704 » Mon Oct 07, 2013 9:06 am

Finished products before assembly:
Image
Image
I decided to skip covering the sides of the fuselage, so I can access the rubber motor easily.
Image
Image
Looks like I can get it at 25 g AUW :o .
Again, I am focusing only on flight and not much on appearance.
Anirudh
Sai1704
 
Posts: 77
Joined: Mon Aug 19, 2013 7:14 am
Location: Bangalore, India

Re: Scratch build : #905 Mustang

Postby birdbuster » Mon Oct 07, 2013 6:44 pm

It seems to me that leaving the sides of the fuselage open would cause a lot of drag.
birdbuster
 
Posts: 21
Joined: Fri Nov 30, 2012 11:57 am

Re: Scratch build : #905 Mustang

Postby Sai1704 » Wed Oct 09, 2013 9:38 am

Birdbuster, I think I'll test it open on a few flights and if it causes too much of a hindrance, I'll cover that up too

Here is the finished Mustang, no decals, no paint, ready for flight tests.
Image
Image
Image

Some day in the near future, I hope I find a good flying field( :shock: ) and get to fly my Cessna 170 and Mustang.
Anirudh
Sai1704
 
Posts: 77
Joined: Mon Aug 19, 2013 7:14 am
Location: Bangalore, India

Previous

Return to General Building Questions

Who is online

Users browsing this forum: No registered users and 29 guests